Ecofires eko 2050 Anleitung zur Fehlerbehebung

INSTALLATION & USER INSTRUCTIONSMODELS COVERED BY THESE INSTRUCTIONSeko 2050INSET DECORATIVE GAS FIRE1Revision C - 12/13' 2013 Focal Point Fi

The fireguards specified in BS 8423 are intended to protect people from falling into a fire, prevent burns and reduce the risk ofinjury, particularly

The pilot is visible through the left hand side of ceramic fuel matrix. When cold, the coals or peb-bles may be rotated for good viewing. The fire fea

This fire is fitted with a flue spillage safety device (ODS). If the fire shuts down during use for no apparent reason then several reasons may be sus

4. Take five more moulded coals and position as shown in figure 10to form the ‘second row’ of the fuel effect. The coals may be rotatedas desired to f

2. Open the bag of 16 ceramic pebbles. All of these pebbles are thesame size. Take five pebbles and place them as shown in figure 14.Care should b

1. Refer back to section 6.0 - Fuel bed layout (coal effect option) and fol-low steps 1 and 2. The fuel effect matrix used for log effect versions ist

Before carrying out any of the following operations, ensure that the fire is OFF and completely cold.FIREFRONT - Any dust accumulating in the firefron

The 3 year guarantee only covers products purchased on or after 1st February 2009. For all gas fires purchased the 3 year guaranteecommences from the

• This appliance is an Inset Decorative Fuel Effect appliance which provides radiant warmth utilising the latest type burner technology.• The fire is

2.0 APPLIANCE DATA3GB IE' 2013 Focal Point Fires plc.3.0 INSTALLATION REQUIREMENTSThis appliance MUST NOT be installed into a room containing a b

4.0 SITE REQUIREMENTS - CONTINUEDAny type of fire surround used with this appliance must be adequately sealed to the wall and floor.A combustible shel

Please refer to the relevant section of the user manual.Unwrap the firefront and ashpan door. Place the firefront directly in front of the fire and sl

The gap between the spark electrode and the pilot should be 3.5 - 4.5mm to produce a goodspark. There should be no need to adjust this. If under any c

All instructions must be handed to the user for safekeeping. Show the customer how to light and control the fire. After com-missioning the appliance,

' 2013 Focal Point Fires plc.8Remove the burner unit as in relevant section and pilot unit as described.Clean the pilot assembly with a soft brus

• The installation and Servicing of this fire MUST only be carried out by a competent person in accordance with local Codesand/or Regulations, Buildin